Switching Commands
199
M4100 Series ProSAFE Managed Switches
0/9 2 Not Defined
0/10 3 Class II
0/11 4 Class III
0/12 5 Network Con
show lldp med remote-device detail
Use this command to display detailed information about remote devices that transmit current
LLDP MED data to an interface on the system.
Format show lldp med remote-device detail <slot/port>
Mode Privileged EXEC
Term Definition
Supported
Capabilities
Shows the supported capabilities that were received in MED TLV on this port.
Enabled
capabilities
Shows the enabled capabilities that were enabled in MED TLV on this port.
Device Class Shows the device class as advertized by the device remotely connected to the port.
Network Policy
Information
Shows if network policy TLV is received in the LLDP frames on this port.
Media
Application Type
Shows the application type. Types of applications are unknown, voice, voicesignaling,
guestvoice, guestvoicesignaling, sfotphonevoice, videoconferencing, streamingvideo,
videosignaling.
VLAN Id Shows the VLAN id associated with a particular policy type.
Priority Shows the priority associated with a particular policy type.
DSCP Shows the DSCP associated with a particular policy type.
Unknown Indicates if the policy type is unknown. In this case, the VLAN id, Priority and DSCP are
ignored.
Tagged Indicates if the policy type is using tagged or untagged VLAN.
Hardware
Revision
Shows the hardware version of the remote device.
Firmware
Revision
Shows the firmware version of the remote device.
Software
Revision
Shows the software version of the remote device.
Serial Number Shows the serial number of the remote device.
Manufacturer
Name
Shows the manufacture name of the remote device.