Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Switching Commands

M4100 Series ProSAFE Managed Switches

no spanning-tree edgeport

This command specifies that this port is not an Edge Port within the Common and Internal

Spanning Tree.

spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value.

• Use 802.1d to specify that the switch transmits ST BPDUs rather than MST BPDUs

(IEEE 802.1d functionality supported).

• Use 802.1s to specify that the switch transmits MST BPDUs (IEEE 802.1s functionality

supported).

• Use 802.1w to specify that the switch transmits RST BPDUs rather than MST BPDUs

(IEEE 802.1w functionality supported).

no spanning-tree forceversion

This command sets the Force Protocol Version parameter to the default value.

spanning-tree forward-time

This command sets the Bridge Forward Delay parameter to a new value for the Common and

Internal Spanning Tree. The forward-time value is in seconds within a range of 4–30, with the

value being greater than or equal to “(Bridge Max Age / 2) + 1”.

Format no spanning-tree edgeport

Mode Interface Config

Default 802.1s

Format spanning-tree forceversion {802.1d | 802.1s | 802.1w}

Mode Global Config

Format no spanning-tree forceversion

Mode Global Config

Default 15

Format spanning-tree forward-time <4-30>

Mode Global Config

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General