NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
118
M4100 Series ProSAFE Managed Switches
port-channel local-preference
This command enables the local-preference mode on a port-channel (LAG) interface or
range of interfaces. By default, the local-preference mode for a port-channel is disabled. This
command can be used only on port-channel interfaces.
no port-channel local-preference
This command disables the local-preference mode on a port-channel.
port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default the
static mode for a new port-channel is disabled, which means the port-channel is dynamic.
However if the maximum number of allowable dynamic port-channels are already present in
the system, the static mode for a new port-channel enabled, which means the port-channel is
static. You can only use this command on port-channel interfaces.
no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the default
value. This command will be executed only for interfaces of type port-channel (LAG).
port lacpmode
This command enables Link Aggregation Control Protocol (LACP) on a port.
Default disabled
Format port-channel local-preference
Mode Interface Config
Format no port-channel local-preference
Mode Interface Config
Default disabled
Format port-channel static
Mode Interface Config
Format no port-channel static
Mode Interface Config
Default enabled
Format port lacpmode
Mode Interface Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)