Switching Commands
173
M4100 Series ProSAFE Managed Switches
When you specify the <slot/port> values, the command output displays the information
that is shown in the following table.
When you specify a value for <vlan-id>, the command output displays the information that
is shown in the following table.
show mldsnooping mrouter interface
Use this command to display information about statically configured multicast router attached
interfaces.
MLD Control
Frame Count
Displays the number of MLD Control frames that are processed by the CPU.
VLANs Enabled
for MLD
Snooping
VLANs on which MLD Snooping is enabled.
Term Definition
MLD Snooping
Admin Mode
Indicates whether MLD Snooping is active on the interface.
Fast Leave
Mode
Indicates whether MLD Snooping Fast Leave is active on the VLAN.
Group
Membership
Interval
Shows the amount of time in seconds that a switch will wait for a report from a particular
group on a particular interface, which is participating in the VLAN, before deleting the
interface from the entry. This value may be configured.
Max Response
Time
Displays the amount of time the switch waits after it sends a query on an interface,
participating in the VLAN, because it did not receive a report for a particular group on that
interface. This value may be configured.
Multicast Router
Present
Expiration Time
Displays the amount of time to wait before removing an interface that is participating in
the VLAN from the list of interfaces with multicast routers attached. The interface is
removed if a query is not received. This value may be configured.
Term Definition
VLAN Admin
Mode
Indicates whether MLD Snooping is active on the VLAN.
Format show mldsnooping mrouter interface <slot/port>
Mode Privileged EXEC
Term Definition