NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
205
M4100 Series ProSAFE Managed Switches
no dos-control l4port
This command disables L4 Port Denial of Service protections.
dos-control icmp
This command enables Maximum ICMP Packet Size Denial of Service protections. If the
mode is enabled, Denial of Service prevention is active for this type of attack. If ICMP Echo
Request (PING) packets ingress having a size greater than the configured value, the packets
will be dropped if the mode is enabled.
no dos-control icmp
This command disables Maximum ICMP Packet Size Denial of Service protections.
dos-control smacdmac
This command enables Source MAC address = Destination MAC address (SMAC=DMAC)
Denial of Service protection. If the mode is enabled, Denial of Service prevention is active for
this type of attack. If packets ingress with SMAC=DMAC, the packets will be dropped if the
mode is enabled.
no dos-control smacdmac
This command disables Source MAC address = Destination MAC address (SMAC=DMAC)
Denial of Service protection.
Format no dos-control l4port
Mode Global Config
Default disabled <512>
Format dos-control icmp [<0-1023>]
Mode Global Config
Format no dos-control icmp
Mode Global Config
Default disabled
Format dos-control smacdmac
Mode Global Config
Format no dos-control smacdmac
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)