Utility Commands
414
M4100 Series ProSAFE Managed Switches
no debug ipv6 pimsm packet
Use this command to disable debug tracing of PIMSMv6 packet reception and transmission.
debug lacp packet
This command enables tracing of LACP packets received and transmitted by the switch.
Command example:
(NETGEAR Switch) #debug lacp packet
<15> JAN 01 14:04:51 10.254.24.31-1 DOT3AD[183697744]: dot3ad_debug.c(385) 58 %%
Pkt TX - Intf: 0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1, State: 0x47, Key:
0x36
no debug lacp packet
This command disables tracing of LACP packets.
debug mldsnooping packet
Use this command to trace MLD snooping packet reception and transmission. f you use the
receive option, only received MLD packets are traced. If you use the transmit option,
only transmitted MLD packets are traced. When neither keyword is used in the command,
then all MLD snooping packet traces are dumped. Vital information such as source address,
destination address, control packet type, packet length, and the interface on which the packet
is received or transmitted is displayed on the console.
Default disabled
Format debug ipv6 pimsm packet [receive | transmit]
Mode Privileged EXEC
Format no debug ipv6 pimsm packet [receive | transmit]
Mode Privileged EXEC
Default disabled
Format debug lacp packet
Mode Privileged EXEC
Format no debug lacp packet
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General
