Switching Commands
25
M4100 Series ProSAFE Managed Switches
show port description
This command displays the port description for every port.
show port status
This command displays the Protocol-Based VLAN information for either the entire system, or
for the indicated group.
Term Definition
Group Name The group name of an entry in the Protocol-based VLAN table.
Group ID The group identifier of the protocol group.
Protocol(s) The type of protocol(s) for this group.
VLAN The VLAN associated with this Protocol Group.
Interface(s) Lists the slot/port interface(s) that are associated with this Protocol Group.
Format show port description <slot/port>
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes
Description Shows the port description configured via the “description” command
Format show port status {<slot/port> | all}
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Media Type “Copper” or “Fiber” for combo port.
STP Mode Indicate the spanning tree mode of the port.
Physical Mode Either “Auto” or fixed speed and duplex mode.
Physical Status The actual speed and duplex mode.
Link Status Whether the link is Up or Down.
Loop Status Whether the port is in loop state or not.
Partner Flow
Control
Whether the remote side is using flow control or not.
To Next Page
Loading...
Need help?
General
