Utility Commands
330
M4100 Series ProSAFE Managed Switches
boot host auto-save
This command is used to enable automatically saving the downloaded configuration on the
switch.
no boot host auto-save
This command is used to disable automatically saving the downloaded configuration on the
switch.
boot autoinstall start
The command is used to start Auto Install on the switch. Auto Install tries to download a
config file from a TFTP server.
boot autoinstall stop
The command is used to A user might terminate the Auto Install process at any time prior to
the downloading of the config file. This is most optimally done when the switch is
disconnected from the network, or if the requisite configuration files have not been configured
on TFTP servers. Termination of the Auto Install process ends further periodic requests for a
host-specific file.
boot host retry-count
This command is used to set the number of attempts to download a configuration. The valid
range is from 1 to 6.
Default Disabled
Format boot host auto-save
Mode Privileged EXEC
Format no boot host auto-save
Mode Privileged EXEC
Format boot autoinstall start
Mode Privileged EXEC
Format boot autoinstall stop
Mode Privileged EXEC
Default 3
Format boot host retry-count <count>
Mode Privileged EXEC