NETGEAR M4100 Series ProSAFE User Manual

Utility Commands
395
M4100 Series ProSAFE Managed Switches
DNS Client Commands
These commands are used in the Domain Name System (DNS), an Internet directory
service. DNS is how domain names are translated into IP addresses. When enabled, the
DNS client provides a hostname lookup service to other components.
ip domain lookup
Use this command to enable the DNS client.
no ip domain lookup
Use this command to disable the DNS client.
ip domain name
Use this command to define a default domain name that the software uses to complete
unqualified host names (names with a domain name).
By default, no default domain name is
configured in the system. <name> may not be longer than 255 characters and should not
include an initial period. This <name> should be used only when the default domain name
list, configured using the ip domain list command, is empty.
Command example:
The CLI command ip domain name yahoo.com configures yahoo.com as a default
domain name. For an unqualified hostname xxx, a DNS query is made to find the IP address
corresponding to xxx.yahoo.com.
Detection
Method
The manner in which the IP address of the hosts were found on the DHCP Server.
Detection time The time when the conflict was found.
Default enabled
Format ip domain lookup
Mode Global Config
Format no ip domain lookup
Mode Global Config
Default none
Format ip domain name <name>
Mode Global Config
Term Definition

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)