Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Switching Commands

M4100 Series ProSAFE Managed Switches

Port Configuration Commands

This section describes the commands you use to view and configure port settings.

interface

This command gives you access to the Interface Config mode, which allows you to enable or

modify the operation of an interface (port).

interface vlan

This command gives you access to the vlan virtual interface mode, which allows certain port

configurations (for example, the IP address) to be applied to the VLAN interface. Type a

question mark (?) after entering the interface configuration mode to see the available options.

interface lag

This command gives you access to the LAG (link aggregation, or port channel) virtual

interface, which allows certain port configurations to be applied to the LAG interface. Type a

question mark (?) after entering the interface configuration mode to see the available options.

Note: The IP address cannot be assigned to a LAG virtual interface. The

interface must be put under a VLAN group and an IP address

assigned to the VLAN group.

auto-negotiate

This command enables automatic negotiation on a port.

Format interface <slot/port>

Mode Global Config

Format interface vlan <vlan id>

Mode Global Config

Format interface lag <lag id>

Mode Global Config

Default enabled

Format auto-negotiate

Mode Interface Config

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General