Quality of Service Commands
291
M4100 Series ProSAFE Managed Switches
If the policy name is not specified, this command displays a list of all defined DiffServ
policies. The fields that are shown in the following table are displayed.
show diffserv service
This command displays policy service information for the specified interface and direction.
The <slot/port> parameter specifies a valid slot/port number for the system.
show diffserv service brief
This command displays all interfaces in the system to which a DiffServ policy has been
attached. The inbound direction parameter is optional.
Policing Style The style of policing, if any, used (simple).
Redirect Forces a classified traffic stream to a specified egress port (physical or LAG). This can
occur in addition to any marking or policing action. It might also be specified along with a
QoS queue assignment.
Term Definition
Policy Name The name of this policy. (The order in which the policies are displayed is not necessarily
the same order in which they were created.)
Policy Type The policy type (Only inbound is supported).
Class Members List of all class names associated with this policy.
Format show diffserv service <slot/port> [in | out]
Mode Privileged EXEC
Term Definition
DiffServ Admin
Mode
The current setting of the DiffServ administrative mode. An attached policy is only in
effect on an interface while DiffServ is in an enabled mode.
Interface Valid slot and port number separated by forward slashes.
Direction The traffic direction of this interface service.
Operational
Status
The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface in the indicated direction.
Policy Details Attached policy details, whose content is identical to that described for the show
policy-map <policymapname> command (content not repeated here for brevity).
Format show diffserv service brief [in | out]
Mode Privileged EXEC
Term Definition
To Next Page
Loading...
Need help?
General
