NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
150
M4100 Series ProSAFE Managed Switches
no ip arp inspection limit
Use this command to set the rate limit and burst interval values for an interface to the default
values of 15 pps and 1 second, respectively.
ip arp inspection filter
Use this command to configure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges. If you enter the static keyword, packets that do not
match a permit statement are dropped without consulting the DHCP snooping bindings.
no ip arp inspection filter
Use this command to unconfigure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges.
arp access-list
Use this command to create an ARP ACL.
no arp access-list
Use this command to delete a configured ARP ACL.
Format no ip arp inspection limit
Mode Interface Config
Default No ARP ACL is configured on a VLAN
Format ip arp inspection filter <acl-name> vlan <vlan-list> [static]
Mode Global Config
Format no ip arp inspection filter <acl-name> vlan <vlan-list> [static]
Mode Global Config
Format arp access-list <acl-name>
Mode Global Config
Format no arp access-list <acl-name>
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)