Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Utility Commands

367

M4100 Series ProSAFE Managed Switches

traceroute ipv6

Use the traceroute command to discover the routes that packets actually take when

traveling to their destination through the network on a hop-by-hop basis. The IPv6 address or

host name must be a valid. The optional <port> parameter is the UDP port used as the

destination of packets sent as part of the traceroute. This port should be an unused port on

the destination system. The range for <port> is zero (0) to 65535. The default value is

33434.

clear config

This command resets the configuration to the factory defaults without powering off the switch.

When you issue this command, a prompt appears to confirm that the reset should proceed.

When you enter y, you automatically reset the current configuration on the switch to the

default values. It does not reset the switch.

clear eventlog

This command clears all event messages maintained in the switch.

clear mac-addr-table

This command clears the dynamically learned MAC addresses of the switch.

clear logging buffered

This command clears the messages maintained in the system log.

Default port: 33434

Format traceroute ipv6 {<ipv6-address> | <hostname>} [port <port>]

Mode Privileged EXEC

Format clear config

Mode Privileged EXEC

Format clear eventlog

Mode Privileged EXEC

Format clear mac-addr-table

Mode Privileged EXEC

Format clear logging buffered

Mode Privileged EXEC

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General