Switching Commands
104
M4100 Series ProSAFE Managed Switches
no storm-control unicast
This command disables unicast storm recovery mode for an interface.
storm-control unicast level (Interface Config)
This command configures the unicast storm recovery threshold for an interface as a
percentage of link speed, and enables unicast storm recovery. If the mode is enabled, unicast
storm recovery is active, and if the rate of unknown L2 unicast (destination lookup failure)
traffic ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured
threshold. This command also enables unicast storm recovery mode for an interface.
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value for an interface
and disables unicast storm recovery.
storm-control unicast rate (Interface Config)
Use this command to configure the unicast storm recovery threshold for an interface in
packets per second. If the mode is enabled, unicast storm recovery is active, and if the rate of
L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the
traffic is dropped. Therefore, the rate of unicast traffic is limited to the configured threshold.
Format no storm-control unicast
Mode Interface Config
Default 5
Format storm-control unicast level <0-100>
Mode Interface Config
Format no storm-control unicast level
Mode Interface Config
Default 0
Format storm-control unicast rate <0-14880000>
Mode Interface Config
To Next Page
Loading...
Need help?
General
