Switching Commands
106
M4100 Series ProSAFE Managed Switches
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value and disables
unicast storm recovery for all interfaces.
storm-control unicast rate (Global Config)
Use this command to configure the unicast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, unicast storm recovery is active, and if the rate of
L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the
traffic is dropped. Therefore, the rate of unicast traffic is limited to the configured threshold.
no storm-control unicast rate
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery.
show storm-control
This command displays switch configuration information. If you do not use any of the optional
parameters, this command displays global storm control configuration parameters:
• Broadcast Storm Control Mode. Might be enabled or disabled. The factory default is
disabled.
• Broadcast Storm Control Level. The factory default is 5 percent.
• Multicast Storm Control Mode. Might be enabled or disabled. The factory default is
disabled.
• Multicast Storm Control Level. The factory default is 5 percent.
• Unicast Storm Control Mode. Might be enabled or disabled. The factory default is
disabled.
• Unicast Storm Control Level. The factory default is 5 percent.
Format no storm-control unicast level
Mode Global Config
Default 0
Format storm-control unicast rate <0-14880000>
Mode Global Config
Format no storm-control unicast rate
Mode Global Config
To Next Page
Loading...
Need help?
General
