Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Switching Commands

M4100 Series ProSAFE Managed Switches

no vlan protocol group add protocol

This command removes the <protocol> from this protocol-based VLAN group that is

identified by this <groupid>. The possible values for protocol are ip, arp, and ipx.

protocol group

This command attaches a <vlanid> to the protocol-based VLAN identified by <groupid>.

A group may only be associated with one VLAN at a time, however the VLAN association can

be changed.

no protocol group

This command removes the <vlanid> from this protocol-based VLAN group that is

identified by this <groupid>.

protocol vlan group

This command adds the physical interface to the protocol-based VLAN identified by

<groupid>. You can associate multiple interfaces with a group, but you can only associate

each interface and protocol combination with one group. If adding an interface to a group

causes any conflicts with protocols currently associated with the group, this command fails

and the interface(s) are not added to the group.

Format no vlan protocol group add protocol <groupid> <ethertype>

{<protocol-list> | arp | ip | ipx}

Mode Global Config

Default none

Format protocol group <groupid> <vlanid>

Mode VLAN Config

Format no protocol group <groupid> <vlanid>

Mode VLAN Config

Default none

Format protocol vlan group <groupid>

Mode Interface Config

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General