NETGEAR M4100 Series ProSAFE

Quality of Service Commands
314
M4100 Series ProSAFE Managed Switches
no auto-voip oui-based priority
This command is used to set the priority to the default value.
auto-voip protocol-based
This command is used to configure the global protocol based auto-VoIP remarking
priority/traffic-class. If the remark priority is configured, the voice data of the session is
remarked with the priority configured through this command.
Note: You must enable tagging on auto-VoIP-enabled ports to remark the
voice data when it is egressed.
• Global Config
• Interface Config
no auto-voip protocol-based {remark | traffic-class}
This command is used to set the traffic-class to the default value.
• Global Config
• Interface Config
show auto-voip
Use this command to display the auto VoIP settings on the interface or interfaces of the switch.
Format no auto-voip oui-based priority <priority-value>
Mode Global Config
Default Traffic-class 7
Format auto-voip protocol-based {remark <remark-priority> | traffic-class
<tc>}
Mode
Format no auto-voip protocol-based {remark <remark-priority> |
traffic-class <tc>}
Mode
Format show auto-voip {protocol-based | oui-based} interface {<slot/port>
| all}
Mode Privileged EXEC
Field Description
VoIP The global VoIP VLAN ID.
Prioritize Type The type of prioritization used on voice traffic.