NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
75
M4100 Series ProSAFE Managed Switches
no set garp timer leave
This command sets the GVRP leave time on all ports or a single port to the default and only
has an ef
fect when GVRP is enabled.
• Interface Config
• Global Config
set garp timer leaveall
This command sets how frequently Leave All PDUs are generated. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in order
to maintain registration. The value applies per port and per GARP participation. The time
may range from 200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds.
You can use this command on all ports (Global Config mode) or a single port (Interface
Config mode), and it only has an effect only when GVRP is enabled.
• Interface Config
• Global Config
no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated the default and only has
an ef
fect when GVRP is enabled.
• Interface Config
• Global Config
Default 60
Format set garp timer leave <20-600>
Mode • Interface Config
• Global Config
Format no set garp timer leave
Mode
Default 1000
Format set garp timer leaveall <200-6000>
Mode
Format no set garp timer leaveall
Mode

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)