Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Switching Commands

M4100 Series ProSAFE Managed Switches

mode dvlan-tunnel

Use this command to enable Double VLAN Tunneling on the specified interface.

Note: When you use the mode dvlan-tunnel command on an interface,

it becomes a service provider port. Ports that do not have double

VLAN tunneling enabled are customer ports.

no mode dvlan-tunnel

This command is used to disable Double VLAN Tunneling on the specified interface. By

default, Double VLAN

Tunneling is disabled.

show dot1q-tunnel

Use this command without the optional parameters to display all interfaces enabled for

Double VLAN Tunneling. Use the optional parameters to display detailed information about

Double VLAN Tunneling for the specified interface or all interfaces.

• Privileged EXEC

• User EXEC

Default disabled

Format mode dvlan-tunnel

Mode

Interface Config

Format no mode dvlan-tunnel

Mode Interface Config

Format show dot1q-tunnel [interface {<slot/port> | all}]

Mode

Term Definition

Interface Valid slot and port number separated by forward slashes.

Mode The administrative mode through which Double VLAN Tunneling can be enabled or

disabled. The default value for this field is disabled.

EtherType A 2-byte hex EtherType to be used as the first 16 bits of the DVLAN tunnel. There are

three different EtherType tags. The first is 802.1Q, which represents the commonly used

value of 0x8100. The second is vMAN, which represents the commonly used value of

0x88A8. If EtherType is not one of these two values, it is a custom tunnel value,

representing any value in the range of 0–65535.

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General