NETGEAR M4100 Series ProSAFE

Utility Commands
333
M4100 Series ProSAFE Managed Switches
update bootcode
This command updates the bootcode (boot loader) on the switch. The bootcode is read from
the active-image for subsequent reboots. The optional <unit> parameter is valid only on
Stacks. Error will be returned, if this parameter is provided, on Standalone systems. For
Stacking, the <unit> parameter identifies the node on which this command must be
executed. When this parameter is not supplied, the command is executed on all nodes in a
Stack.
System Information and Statistics Commands
This section describes the commands you use to view information about system features,
components, and configurations.
show arp switch (system information and statistics commands)
This command displays the contents of the IP stack’s Address Resolution Protocol (ARP)
table. The IP stack only learns ARP entries associated with the management interfaces
(network or service ports). ARP entries associated with routing interfaces are not listed.
show eventlog
This command displays the event log, which contains error messages from the system. The
event log is not cleared on a system reset. The <unit> is the switch identifier.
Format update bootcode [<unit>]
Mode Privileged EXEC
Format show arp switch
Mode Privileged EXEC
Term Definition
IP Address IP address of the management interface or another device on the management network.
MAC Address Hardware MAC address of that device.
Interface For a service port the output is Management. For a network port, the output is the
slot/port of the physical interface.
Format show eventlog [<unit>]
Mode Privileged EXEC