NETGEAR M4100 Series ProSAFE User Manual

Utility Commands
375
M4100 Series ProSAFE Managed Switches
Simple Network Time Protocol (SNTP) Commands
This section describes the commands you use to automatically configure the system time
and date by using SNTP.
sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 10.
no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default value.
sntp client mode
This command enables Simple Network Time Protocol (SNTP) client mode and might set the
mode to either broadcast or unicast.
no sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
Default 6
Format sntp broadcast client poll-interval <poll-interval>
Mode Global Config
Format no sntp broadcast client poll-interval
Mode Global Config
Default disabled
Format sntp client mode [broadcast | unicast]
Mode Global Config
Format no sntp client mode
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)