NETGEAR M4100 Series ProSAFE

Management Commands
498
M4100 Series ProSAFE Managed Switches
snmp trap link-status
Use this command to enable link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled.
For more information, see
snmp-server enable traps linkmode on
page 495.
no snmp trap link-status
Use this command to disable link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled.
snmp trap link-status all
Use this command to enable link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled.
For more information, see
snmp-server enable traps linkmode on
page 495.
no snmp trap link-status all
Use this command to disable link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled.
For more information, see
snmp-server enable traps linkmode on
page 495.
Format snmp trap link-status
Mode Interface Config
Format no snmp trap link-status
Mode Interface Config
Format snmp trap link-status all
Mode Global Config