Quality of Service Commands
292
M4100 Series ProSAFE Managed Switches
The information that is shown in the following table is repeated for each interface and
direction (only those interfaces configured with an attached policy are shown).
show policy-map interface
This command displays policy-oriented statistics information for the specified interface and
direction. The <slot/port> parameter specifies a valid interface for the system.
Note: This command is only allowed while the DiffServ administrative mode
is enabled.
The information that is shown in the following table is repeated for each class instance within
this policy.
Term Definition
DiffServ Admin
Mode
The current setting of the DiffServ administrative mode. An attached policy is only active
on an interface while DiffServ is in an enabled mode.
Term Definition
Interface Valid slot and port number separated by forward slashes.
Direction The traffic direction of this interface service.
OperStatus The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface in the indicated direction.
Format show policy-map interface <slot/port> [in | out]
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Direction The traffic direction of this interface service.
Operational
Status
The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface in the indicated direction.
Term Definition
Class Name The name of this class instance.
In Discarded
Packets
A count of the packets discarded for this class instance for any reason due to DiffServ
treatment of the traffic class.
To Next Page
Loading...
Need help?
General
