Switching Commands
153
M4100 Series ProSAFE Managed Switches
Command example:
The following example shows CLI output for the show ip arp inspection statistics
command, which lists the summary of forwarded and dropped ARP packets on all
DAI-enabled VLANs.
VLAN Forwarded Dropped
---- --------- -------
10 90 14
20 10 3
Command example:
(NETGEAR Switch) #show ip arp inspection statistics vlan <vlan-list>
VLAN DHCP ACL DHCP ACL Bad Src Bad Dest Invalid
Drops Drops Permits Permits MAC MAC IP
----- -------- --------- ----------- --------- ---------- ----------- ---------
10 11 1 65 25 1 1 0
20 1 0 8 2 0 1 1
clear ip arp inspection statistics
Use this command to reset the statistics for Dynamic ARP Inspection on all VLANs.
show ip arp inspection interfaces
Use this command to display the Dynamic ARP Inspection configuration on all the
DAI-enabled interfaces. An interface is said to be enabled for DAI if at least one VLAN, that
the interface is a member of, is enabled for DAI. If you enter the <slot/port> interface
argument, the command displays the values for that interface whether the interface is
enabled for DAI or not.
• Privileged EXEC
• User EXEC
Default none
Format clear ip arp inspection statistics
Mode
Privileged EXEC
Format show ip arp inspection interfaces [<slot/port>]
Mode
Term Definition
Interface The interface ID for each displayed row.
Trust State Whether the interface is trusted or untrusted for DAI.
To Next Page
Loading...
Need help?
General
