NETGEAR M4100 Series ProSAFE

Management Commands
516
M4100 Series ProSAFE Managed Switches
tacacs-server source interface
Use this command in Global Configuration mode to configure the global source interface
(source IP selection) for all TACACS+ communications between the TACACS+ client and the
server.
no tacacs-server source interface
Use this command in Global Configuration mode to remove the global source interface
(source IP selection) for all TACACS+ communications between the TACACS+ client and the
server.
tacacs-server timeout
Use this command to set the timeout value for communication with the TACACS+ servers.
The <timeout> parameter has a range of 1-30 and is the time-out value in seconds.
no tacacs-server timeout
Use this command to restore the default time-out value for all TACACS servers.
Format tacacs-server source-interface {<slot/port> | loopback <loopback-id>
| vlan <vlan-id>}
Mode Global Config
Parameter Description
<slot/port The unit identifier assigned to the switch.
<loopback-id The loopback interface. The range is 0–7.
<vlan-id> The VLAN ID. The range is 1–4,093.
Format no tacacs-server source-interface
Mode Privileged Exec
Default 5
Format tacacs-server timeout <timeout>
Mode Global Config
Format no tacacs-server timeout
Mode Global Config