NETGEAR M4100 Series ProSAFE

Management Commands
497
M4100 Series ProSAFE Managed Switches
Note: This command does not support a no form.
snmptrap ipaddr
Use this command to assign an IP address to a specified community name. The name can
use up to 16 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you
make multiple entries using the same IP address, the first entry is
retained and processed. All duplicate entries are ignored.
snmptrap mode
Use this command to activate or deactivate an SNMP trap. Enabled trap receivers are active
(able to receive traps). Disabled trap receivers are inactive (not able to receive traps).
no snmptrap mode
Use this command to deactivate an SNMP trap. Disabled trap receivers are unable to receive
traps.
Default snmpv2
Format snmptrap snmpversion <name> {<ipaddr> | <hostname>} | {<ip6addr> |
<hostname>} {snmpv1 | snmpv2}
Mode Global Config
Format snmptrap ipaddr <name> <ipaddrold> {<ipaddrnew | hostnamenew>}
Mode Global Config
Format snmptrap mode <name> {<ipaddr> | <ip6addr> | <hostname>}
Mode Global Config
Format no snmptrap mode <name> {<ipaddr> | <ip6addr> | <hostname>}
Mode Global Config