Management Commands
496
M4100 Series ProSAFE Managed Switches
no snmp-server enable traps stpmode
Use this command to disable sending new root traps and topology change notification traps.
snmptrap
Use this command to add an SNMP trap receiver. The maximum length of <name> is
16
case-sensitive alphanumeric characters. The <snmpversion> is the version of SNMP.
The version parameter options are SNMPv1 or SNMPv2. The SNMP trap address can be set
using both an IPv4 address format as well as an IPv6 global address format.
The <name> parameter does not need to be unique. However, the combination of the name
and IP address or host name must be unique. Multiple entries can exist with the same
<name> parameter, as long as they are associated with a different IP address or host name.
The reverse scenario is also acceptable. The <name> parameter is the community name that
is used when the trap is sent to the receiver, but the <name> parameter is not directly
associated with the SNMP Community Table (see
snmp-server community on page 491).
Command example:
(Netgear Switch)# snmptrap mytrap ip6addr 3099::2
no snmptrap
Use this command to delete trap receivers for a community.
snmptrap snmpversion
Use this command to modify the SNMP version of a trap. The maximum length of <name> is
16 case-sensitive alphanumeric characters. The <snmpversion> parameter options are
snmpv1 or snmpv2.
Format no snmp-server enable traps stpmode
Mode Global Config
Default snmpv2
Format snmptrap <name> {ipaddr {<ipaddr> | <hostname> | ip6addr {<ip6addr>
| <hostname>} [snmpversion <snmpversion>]
Mode Global Config
Format no snmptrap <name> {ipaddr {<ipaddr> | <hostname> | ip6addr
{<ip6addr> | <hostname>}
Mode Global Config
To Next Page
Loading...
Need help?
General
