Utility Commands
431
M4100 Series ProSAFE Managed Switches
IP Address Conflict Commands
ip address-conflict-detect run
This command triggers the switch to run active address conflict detection by sending
gratuitous ARP packets for IPv4 addresses on the switch.
Note: This command takes effect only once after it is executed and cannot
be saved across power cycles.
show ip address-conflict
This command displays the status information corresponding to the last detected address
conflict.
clear ip address-conflict-detect
This command clears the detected address conflict status information.
Format ip address-conflict-detect run
Mode Global Config
Format show ip address-conflict
Modes Privileged EXEC
Term Definition
Address Conflict
Detection Status
Identifies whether the switch has detected an address conflict on any IP address.
Last Conflicting
IP Address
The IP Address that was last detected as conflicting on any interface.
Last Conflicting
MAC Address
The MAC Address of the conflicting host that was last detected on any interface.
Time Since
Conflict Detected
The time in days, hours, minutes and seconds since the last address conflict was
detected.
Format clear ip address-conflict-detect
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General
