Utility Commands
336
M4100 Series ProSAFE Managed Switches
If the argument is switchport, the display parameters are as shown in the following table.
show interface counters
This command reports key summary statistics for all ports (physical, CPU, and port-channel).
Collisions
Frames
The best estimate of the total number of collisions on this Ethernet segment.
Time Since
Counters Last
Cleared
The elapsed time, in days, hours, minutes, and seconds since the statistics for this port
were last cleared.
Term Definition
Packets
Received
Without Error
The total number of packets (including broadcast packets and multicast packets)
received by the processor.
Broadcast
Packets
Received
The total number of packets received that were directed to the broadcast address. Note
that this does not include multicast packets.
Packets
Received With
Error
The number of inbound packets that contained errors preventing them from being
deliverable to a higher-layer protocol.
Packets
Transmitted
Without Error
The total number of packets transmitted out of the interface.
Broadcast
Packets
Transmitted
The total number of packets that higher-level protocols requested to be transmitted to the
Broadcast address, including those that were discarded or not sent.
Transmit Packet
Errors
The number of outbound packets that could not be transmitted because of errors.
Address Entries
Currently In Use
The total number of Forwarding Database Address table entries now active on the
switch, including learned and static entries.
VLAN Entries
Currently In Use
The number of VLAN entries presently occupying the VLAN table.
Time Since
Counters Last
Cleared
The elapsed time, in days, hours, minutes, and seconds since the statistics for this
switch were last cleared.
Format show interface counters
Mode Privileged EXEC
Parameters Definition
To Next Page
Loading...
Need help?
General
