NETGEAR M4100 Series ProSAFE

Switching Commands
112
M4100 Series ProSAFE Managed Switches
lacp actor admin state longtimeout
Use this command to set LACP actor admin state to longtimeout.
Note: This command is only applicable to physical interfaces.
no lacp actor admin state longtimeout
Use this command to set the LACP actor admin state to short timeout.
Note: This command is only applicable to physical interfaces.
lacp actor admin state passive
Use this command to set the LACP actor admin state to passive.
Note: This command is only applicable to physical interfaces.
no lacp actor admin state passive
Use this command to set the LACP actor admin state to active.
Format lacp actor admin state longtimeout
Mode Interface Config
Format no lacp actor admin state longtimeout
Mode Interface Config
Format lacp actor admin state passive
Mode Interface Config
Format no lacp actor admin state passive
Mode Interface Config