Quality of Service Commands
267
M4100 Series ProSAFE Managed Switches
no random-detect queue-parms
Use this command to set the WRED configuration back to the default.
• Global Config
• Interface Config
traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface as a
whole. Also known as rate shaping, traffic shaping has the effect of smoothing temporary
traffic bursts over time so that the transmitted traffic rate is bounded.
• Global Config
• Interface Config
no traffic-shape
This command restores the interface shaping rate to the default value.
• Global Config
• Interface Config
show classofservice dot1p-mapping
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes
for a specific interface. The <slot/port> parameter is optional and is only valid on
platforms that support independent per-port Class of Service mappings. If specified, the
802.1p mapping table of the interface is displayed. If omitted, the most recent global
configuration settings are displayed. For more information, see Voice VLAN Commands on
page 65
.
Format random-detect queue-parms <queue-id-1> [<queue-id-2> … <queue-id-n>]
minthresh <thresh-prec-1> … <thresh-prec-n> max-thresh
<thresh-prec-1> … <threshprec-n> drop-probability <prob-prec-1> …
<prob-prec-n>
Modes • Global Config
• Interface Config
Format no random-detect queue-parms <queue-id-1> [<queue-id-2> …
<queue-id-n>]
Modes
Format traffic-shape <bw>
Modes
Format no traffic-shape
Modes
To Next Page
Loading...
Need help?
General
