Switching Commands
218
M4100 Series ProSAFE Managed Switches
debug isdp packet
This command enables tracing of ISDP packets processed by the switch. ISDP must be
enabled on both the device and the interface in order to monitor packets for a particular
interface.
no debug isdp packet
This command disables tracing of ISDP packets on the receive or the transmit sides or on
both sides.
ISDPv1 Packets Received Total number of ISDPv1 packets received
ISDPv1 Packets Transmitted Total number of ISDPv1 packets transmitted
ISDPv2 Packets Received Total number of ISDPv2 packets received
ISDPv2 Packets Transmitted Total number of ISDPv2 packets transmitted
ISDP Bad Header Number of packets received with a bad header
ISDP Checksum Error Number of packets received with a checksum error
ISDP Transmission Failure Number of packets which failed to transmit
ISDP Invalid Format Number of invalid packets received
ISDP Table Full Number of times a neighbor entry was not added to the table due to a full
database
ISDP IP Address Table Full Displays the number of times a neighbor entry was added to the table
without an IP address.
Format debug isdp packet [receive | transmit]
Mode Privileged EXEC
Format no debug isdp packet [receive | transmit]
Mode Privileged EXEC
Term Definition
To Next Page
Loading...
Need help?
General
