NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
181
M4100 Series ProSAFE Managed Switches
no port-security mac-address sticky
The no form removes the sticky mode. The sticky MAC address can be deleted by using the
command no port-security mac-address <mac-address> <vid>.
• Global Config
• Interface Config
show port-security
This command displays the port-security settings. If you do not use a parameter, the
command displays the settings for the entire system. Use the optional parameters to display
the settings on a specific interface or on all interfaces.
For each interface, or for the interface you specify, the following information appears:
show port-security dynamic
This command displays the dynamically locked MAC addresses for the port.
Format no port-security mac-address sticky [<mac-address> <vid>]
Modes
Format show port-security [<slot/port> | all]
Mode Privileged EXEC
Term Definition
Admin Mode Port Locking mode for the entire system. This field displays if you do not supply any
parameters.
Term Definition
Admin Mode Port Locking mode for the Interface.
Dynamic Limit Maximum dynamically allocated MAC Addresses.
Static Limit Maximum statically allocated MAC Addresses.
Violation Trap
Mode
Whether violation traps are enabled.
Format show port-security dynamic [lag <lag-intf-num> | <slot/port>]
Mode Privileged EXEC
Term Definition
MAC Address MAC Address of dynamically locked MAC.

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)