Management Commands
499
M4100 Series ProSAFE Managed Switches
show snmpcommunity
Use this command to display SNMP community information. Six communities are supported.
You can add, change, or delete communities. The switch does not need to be reset for
changes to take effect.
The SNMP agent of the switch complies with SNMP versions 1, 2 or 3. For more information
about the SNMP specification, see the SNMP RFCs. The SNMP agent sends traps through
TCP/IP to an external SNMP manager based on the SNMP configuration (the trap receiver
and other SNMP community parameters).
show snmptrap
Use this command to display SNMP trap receivers. Trap messages are sent across a
network to an SNMP network manager. These messages alert the manager to events
occurring within the switch or on the network. Six trap receivers are simultaneously
supported.
Format no snmp trap link-status all
Mode Global Config
Format show snmpcommunity
Mode Privileged EXEC
Field Definition
SNMP
Community
Name
The community string to which this entry grants access. A valid entry is a case-sensitive
alphanumeric string of up to 16 characters. Each row of this table must contain a unique
community name.
Client IP
Address
An IP address (or portion thereof) from which this device will accept SNMP packets with
the associated community. The requesting entity's IP address is ANDed with the Subnet
Mask before being compared to the IP address. Note: If the Subnet Mask is set to
0.0.0.0, an IP address of 0.0.0.0 matches all IP addresses. The default value is 0.0.0.0.
Client IP Mask A mask to be ANDed with the requesting entity's IP address before comparison with IP
address. If the result matches with IP address then the address is an authenticated IP
address. For example, if the IP address = 9.47.128.0 and the corresponding Subnet
Mask = 255.255.255.0 a range of incoming IP addresses would match, i.e. the incoming
IP address could equal 9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0.
Access Mode The access level for this community string.
Status The status of this community access entry.
Format show snmptrap
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General
