Switching Commands
30
M4100 Series ProSAFE Managed Switches
spanning-tree configuration name
This command sets the Configuration Identifier Name for use in identifying the configuration
that this switch is currently using. The <name> is a string of up to 32 characters.
no spanning-tree configuration name
This command resets the Configuration Identifier Name to its default.
spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision Level is
a number in the range of 0–65535.
no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value.
spanning-tree edgeport
This command specifies that this port is an Edge Port within the Common and Internal
Spanning Tree. This allows this port to transition to Forwarding State without delay.
Default base MAC address in hexadecimal notation
Format spanning-tree configuration name <name>
Mode Global Config
Format no spanning-tree configuration name
Mode Global Config
Default 0
Format spanning-tree configuration revision <0-65535>
Mode Global Config
Format no spanning-tree configuration revision
Mode Global Config
Default Enabled
Format spanning-tree edgeport
Mode Interface Config
To Next Page
Loading...
Need help?
General
