Switching Commands
157
M4100 Series ProSAFE Managed Switches
set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval time on a VLAN, one interface, or
all interfaces. The Group Membership Interval time is the amount of time in seconds that a
switch waits for a report from a particular group on a particular interface before deleting the
interface from the entry. This value must be greater than the IGMPv3 Maximum Response
time value. The range is 2–3600 seconds.
• Interface Config
• Global Config
no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
• Interface Config
• Global Config
set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, or on a particular
interface or VLAN. The Maximum Response time is the amount of time in seconds that a
switch will wait after sending a query on an interface because it did not receive a report for a
particular group in that interface. This value must be less than the IGMP Query Interval time
value. The range is 1–25 seconds.
• Global Config
• Interface Config
Default 260 seconds
Format set igmp groupmembership-interval <2-3600>
Mode
Format set igmp groupmembership-interval <vlan id> <2-3600>
Mode
VLAN Config
Format no set igmp groupmembership-interval
Mode
Format no set igmp groupmembership-interval <vlan id>
Mode VLAN Config
Default 10 seconds
Format set igmp maxresponse <1-25>
Mode
Format set igmp maxresponse <vlan id> <1-25>
Mode
VLAN Config
To Next Page
Loading...
Need help?
General
