Utility Commands
378
M4100 Series ProSAFE Managed Switches
clock timezone
When using SNTP/NTP time servers to update the switch’s clock, the time data received
from the server is based on Coordinated Universal Time (UTC) which is the same as
Greenwich Mean Time (GMT). This might not be the time zone in which the switch is located.
Use the clock timezone command to configure a time zone specifying the number of
hours and optionally the number of minutes difference from UTC. To set the switch clock to
UTC, use the no form of the command.
no clock timezone
This command sets the switch to UTC time.
clock set
This command sets the system time and date.
clock summer-time recurring
Use this command to set the summertime offset to UTC recursively every year. If the optional
parameters are not specified, they are read as either 0 or \0, as appropriate.
Use the following parameters to configure the summer-time.
• USA—the US Daylight saving time setting is used (Start --- March, 2nd sunday 02:00 AM,
End --- Nov, 1st sunday, 2:00 AM)
• EU—the European Union Daylight savings time is used (Start --- March, 5th Sunday
02:00 AM, End --- October, 5th Sunday, 3:00 AM)
Default no clock timezone
Format clock timezone <zone-name> <+/-hours-offset> [<+/-minutes-offset>]
Mode Global Config
Term Definition
<zone-name> A name to associate with the time zone
<hours-offset> Number of hours difference with UTC
<minutes-offset> Number of minutes difference with UTC
Format no clock timezone
Mode Global Config
Format clock set <hh:mm:ss>
clock set <mm/dd/yyyy>
Mode Global Config
To Next Page
Loading...
Need help?
General
