Switching Commands
100
M4100 Series ProSAFE Managed Switches
the rate of broadcast traffic will be limited to the configured threshold. This command also
enables broadcast storm recovery mode for all interfaces.
If the ‘shutdown’ option is selected, and the broadcast traffic increases beyond the threshold,
the interface shuts down instead of dropping packets. To recover the port, issue ‘no
shutdown’ under the port manually.
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for all
interfaces and disables broadcast storm recovery.
storm-control broadcast rate (Global Config)
Use this command to configure the broadcast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, broadcast storm recovery is active, and if the
rate of L2 broadcast traffic ingressing on an interface increases beyond the configured
threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is limited to the
configured threshold.
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for all
interfaces and disables broadcast storm recovery.
Default 5
Format storm-control broadcast level <0-100>
Mode Global Config
Format no storm-control broadcast level
Mode Global Config
Default 0
Format storm-control broadcast rate <0-14880000>
Mode Global Config
Format no storm-control broadcast rate
Mode Global Config