NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
111
M4100 Series ProSAFE Managed Switches
no lacp collector max delay
Use this command to configure the default port-channel collector max delay.
lacp actor admin key
Use this command to configure the administrative value of the LACP actor admin key. The
valid range for <key> is 0-65535.
Note: This command is only applicable to physical interfaces.
no lacp actor admin key
Use this command to configure the default administrative value of the key.
lacp actor admin state individual
Use this command to set LACP actor admin state to individual.
Note: This command is only applicable to physical interfaces.
no lacp actor admin state individual
Use this command to set the LACP actor admin state to aggregation.
Format no lacp collector max-delay
Mode Interface Config
Default Internal Interface Number of this Physical Port
Format lacp actor admin key <key>
Mode Interface Config
Format no lacp actor admin key
Mode Interface Config
Format lacp actor admin state individual
Mode Interface Config
Format no lacp actor admin state individual
Mode Interface Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)