NETGEAR M4100 Series ProSAFE

Switching Commands
214
M4100 Series ProSAFE Managed Switches
isdp timer
This command sets the period of time between sending new ISDP packets. You must enter
the range in seconds.
isdp advertise-v2
This command enables the sending of ISDP version 2 packets from the device.
no isdp advertise-v2
This command disables the sending of ISDP version 2 packets from the device.
isdp enable
This command enables ISDP on the interface.
no isdp enable
This command disables ISDP on the interface.
Default 30 seconds
Format isdp timer <5-254>
Mode Global Config
Default Enabled
Format isdp advertise-v2
Mode Global Config
Format no isdp advertise-v2
Mode Global Config
Default Enabled
Format isdp enable
Mode Interface Config
Format no isdp enable
Mode Interface Config