NETGEAR M4100 Series ProSAFE

Switching Commands
172
M4100 Series ProSAFE Managed Switches
no set mld mrouter
Use this command to disable multicast router attached mode for a VLAN with a particular
VLAN ID.
set mld mrouter interface
Use this command to configure the interface as a multicast router-attached interface. When
configured as a multicast router interface, the interface is treated as a multicast
router-attached interface in all VLANs.
no set mld mrouter interface
Use this command to disable the status of the interface as a statically configured multicast
router-attached interface.
show mldsnooping
Use this command to display MLD Snooping information. Configured information is displayed
whether or not MLD Snooping is enabled.
When the optional arguments <slot/port> or <vlan-id> are not used, the command
output displays the information that is shown in the following table.
Format no set mld mrouter <vlan-id>
Mode Interface Config
Default disabled
Format set mld mrouter interface
Mode Interface Config
Format no set mld mrouter interface
Mode Interface Config
Format show mldsnooping [<slot/port> | <vlan-id>]
Mode Privileged EXEC
Term Definition
Admin Mode Indicates whether or not MLD Snooping is active on the switch.
Interfaces
Enabled for MLD
Snooping
Interfaces on which MLD Snooping is enabled.