NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
139
M4100 Series ProSAFE Managed Switches
no ip dhcp snooping vlan
Use this command to disable DHCP Snooping on VLANs.
ip dhcp snooping verify mac-address
Use this command to enable verification of the source MAC address with the client hardware
address in the received DCHP message.
no ip dhcp snooping verify mac-address
Use this command to disable verification of the source MAC address with the client hardware
address.
ip dhcp snooping database
Use this command to configure the persistent location of the DHCP Snooping database. This
can be local or a remote file on a specified computer.
ip dhcp snooping database write-delay
Use this command to configure the interval in seconds at which the DHCP Snooping
database will be persisted. The interval value ranges from 15 to 86,400 seconds.
Format no ip dhcp snooping vlan <vlan-list>
Mode Global Config
Default enabled
Format ip dhcp snooping verify mac-address
Mode Global Config
Format no ip dhcp snooping verify mac-address
Mode Global Config
Default local
Format ip dhcp snooping database {local | <tftp://hostIP> / <filename>}
Mode Global Config
Default 300 seconds
Format ip dhcp snooping database write-delay <seconds>
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)