Switching Commands
83
M4100 Series ProSAFE Managed Switches
dot1x max-users
Use this command to set the maximum number of clients supported on the port when
MAC-based dot1x authentication is enabled on the port. The maximum users supported per
port is dependent on the product. The <count> value is in the range 1 - 48.
no dot1x max-users
This command resets the maximum number of clients allowed per port to its default value.
dot1x port-control
This command sets the authentication mode to use on the specified port. Select
force-unauthorized to specify that the authenticator PAE unconditionally sets the
controlled port to unauthorized. Select force-authorized to specify that the authenticator
PAE unconditionally sets the controlled port to authorized. Select auto to specify that the
authenticator PAE sets the controlled port mode to reflect the outcome of the authentication
exchanges between the supplicant, authenticator, and the authentication server. If the
mac-based option is specified, MAC-based dot1x authentication is enabled on the port.
no dot1x port-control
This command sets the 802.1x port control mode on the specified port to the default value.
dot1x port-control all
This command sets the authentication mode to use on all ports. Select
force-unauthorized to specify that the authenticator PAE unconditionally sets the
controlled port to unauthorized. Select force-authorized to specify that the authenticator
PAE unconditionally sets the controlled port to authorized. Select auto to specify that the
Default 48
Format dot1x max-users <count>
Mode Interface Config
Format
no dot1x max-req
Mode Interface Config
Default auto
Format dot1x port-control {force-unauthorized | force-authorized | auto |
mac-based}
Mode Interface Config
Format no dot1x port-control
Mode Interface Config
To Next Page
Loading...
Need help?
General
