NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
119
M4100 Series ProSAFE Managed Switches
no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.
port lacpmode enable all
This command enables Link Aggregation Control Protocol (LACP) on all ports.
no port lacpmode enable all
This command disables Link Aggregation Control Protocol (LACP) on all ports.
port lacptimeout (Interface Config)
This command sets the timeout on a physical interface of a particular device type (actor or
partner) to either long or short time-out.
no port lacptimeout
This command sets the timeout back to its default value on a physical interface of a particular
device type (actor or partner).
Format no port lacpmode
Mode Interface Config
Format port lacpmode enable all
Mode Global Config
Format no port lacpmode enable all
Mode Global Config
Default long
Format port lacptimeout {actor | partner} {long | short}
Mode Interface Config
Format no port lacptimeout {actor | partner}
Mode Interface Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)