NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
54
M4100 Series ProSAFE Managed Switches
no protocol vlan group
This command removes the interface from this protocol-based VLAN group that is identified
by this <groupid>.
protocol vlan group all
This command adds all physical interfaces to the protocol-based VLAN identified by
<groupid>. You can associate multiple interfaces with a group, but you can only associate
each interface and protocol combination with one group. If adding an interface to a group
causes any conflicts with protocols currently associated with the group, this command will fail
and the interface(s) will not be added to the group.
no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is identified
by this <groupid>.
vlan pvid
This command changes the VLAN ID per interface.
no vlan pvid
This command sets the VLAN ID per interface to 1.
Format no protocol vlan group <groupid>
Mode Interface Config
Default none
Format protocol vlan group all <groupid>
Mode Global Config
Format no protocol vlan group all <groupid>
Mode Global Config
Default 1
Format vlan pvid <1-4093>
Mode Interface Config
Format no vlan pvid
Mode Interface Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)