NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
192
M4100 Series ProSAFE Managed Switches
lldp med confignotification
Use this command to configure all the ports to send the topology change notification.
no ldp med confignotification
Use this command to disable notifications.
lldp med transmit-tlv
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED
set will be transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs).
Note: The current implementation supports one network policy: the voice
VLAN as defined by the voice vlan commands.
Default enabled
Format lldp med confignotification
Mode Interface Config
Format no lldp med confignotification
Mode Interface Config
Default By default, the capabilities and network policy TLVs are included.
Format lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory]
[location] [network-policy]
Mode Interface Config
Parameter Definition
capabilities Transmit the LLDP capabilities TLV.
ex-pd Transmit the LLDP extended PD TLV.
ex-pse Transmit the LLDP extended PSE TLV.
inventory Transmit the LLDP inventory TLV.
location Transmit the LLDP location TLV.
network-policy Transmit the LLDP network policy TLV.

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)