EasyManuals Logo

NETGEAR M4100 Series ProSAFE User Manual

NETGEAR M4100 Series ProSAFE
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #156 background imageLoading...
Page #156 background image
Switching Commands
156
M4100 Series ProSAFE Managed Switches
no set igmp interfacemode
This command disables IGMP Snooping on all interfaces.
set igmp fast-leave
This command enables or disables IGMP Snooping fast-leave admin mode on a selected
interface or VLAN. Enabling fast-leave allows the switch to immediately remove the layer 2
LAN interface from its forwarding table entry upon receiving an IGMP leave message for that
multicast group without first sending out MAC-based general queries to the interface.
You should enable fast-leave admin mode only on VLANs where only one host is connected
to each layer 2 LAN port. This prevents the inadvertent dropping of the other hosts that were
connected to the same layer 2 LAN port but were still interested in receiving multicast traffic
directed to that group. Also, fast-leave processing is supported only with IGMP version 2
hosts.
no set igmp fast-leave
This command disables IGMP Snooping fast-leave admin mode on a selected interface.
Default disabled
Format set igmp interfacemode
Mode Global Config
Format no set igmp interfacemode
Mode Global Config
Default disabled
Format set igmp fast-leave
Mode Interface Config
Format set igmp fast-leave <vlan id>
Mode VLAN Config
Format no set igmp fast-leave
Mode Interface Config
Format no set igmp fast-leave <vlan id>
Mode VLAN Config

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General IconGeneral
Product TypeManaged Switch
Form FactorRack-mountable
LayerLayer 2/Layer 3
ManagementWeb-based, CLI, SNMP
VLAN SupportYes
Quality of Service (QoS)Yes
Security FeaturesACLs, 802.1x
DimensionsVaries by model
WeightVaries by model
Operating Temperature32°F to 122°F (0°C to 50°C)
Storage Temperature-20° to 70° C (-4° to 158° F)
PoE SupportYes (on select models)

Related product manuals