NETGEAR M4100 Series ProSAFE User Manual

Management Commands
495
M4100 Series ProSAFE Managed Switches
snmp-server enable traps linkmode
Use this command to enable Link Up/Down traps for the entire switch. When enabled, link
traps are sent only if the Link Trap flag setting associated with the port is enabled. For more
information, see
snmp trap link-status on page 498.
no snmp-server enable traps linkmode
Use this command to disable Link Up/Down traps for the entire switch.
snmp-server enable traps multiusers
Use this command to enable Multiple User traps. When the traps are enabled, a Multiple
User Trap is sent when a user logs in to the terminal interface (EIA 232 or Telnet) and there
is an existing terminal interface session.
no snmp-server enable traps multiusers
Use this command to disable Multiple User traps.
snmp-server enable traps stpmode
Use this command to enable sending new root traps and topology change notification traps.
Default enabled
Format snmp-server enable traps linkmode
Mode Global Config
Format no snmp-server enable traps linkmode
Mode Global Config
Default enabled
Format snmp-server enable traps multiusers
Mode Global Config
Format no snmp-server enable traps multiusers
Mode Global Config
Default enabled
Format snmp-server enable traps stpmode
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)