Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Switching Commands

M4100 Series ProSAFE Managed Switches

dot1x initialize

This command begins the initialization sequence on the specified port. This command is only

valid if the control mode for the specified port is “auto” or “mac-based”. If the control mode is

not “auto” or “mac-based,” an error is returned.

dot1x mac-auth-bypass

This command enables MAC-Based Authentication Bypass (MAB) for 802.1x-unaware

clients. MAB provides 802.1x-unaware clients controlled access to the network using the

devices’ MAC address as an identifier. This requires that the known and allowable MAC

address and corresponding access rights be pre-populated in the authentication server. MAB

works only when the port control mode of the port is MAC-based.

no dot1x mac-auth-bypass

This command disables MAB for 802.1x-unaware clients.

dot1x max-req

This command sets the maximum number of times the authenticator state machine on this

port will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The

<count> value must be in the range 1 - 10.

no dot1x max-req

This command sets the maximum number of times the authenticator state machine on this

port will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant.

Format dot1x initialize <slot/port>

Mode Privileged EXEC

Format dot1x mac-auth-bypass

Mode Interface Config

Format no dot1x mac-auth-bypass

Mode Interface Config

Default 2

Format dot1x max-req <count>

Mode Interface Config

Format no dot1x max-req

Mode Interface Config

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General