Switching Commands
198
M4100 Series ProSAFE Managed Switches
Location
Subtype: elin
Info: xxx xxx xxx
Extended POE
Device Type: pseDevice
Extended POE PSE
Available: 0.3 Watts
Source: primary
Priority: critical
Extended POE PD
Required: 0.2 Watts
Source: local
Priority: low
show lldp med remote-device
This command displays summary information about remote devices that transmit current
LLDP MED data to the system. You can show information about LLDP remote data received
on all ports or on a specific port.
Command example:
(NETGEAR Switch) #show lldp med remote-device all
LLDP MED Remote Device Summary
Local
Interface Remote ID Device Class
--------- --------- ------------
0/8 1 Class I
Format show lldp med remote-device {<slot/port> | all}
Mode Privileged EXEC
Term Definition
Interface The interface in a slot/port format.
Device Class The Remote device’s MED Classification. There are four different kinds of devices, three
of them represent the actual end points (classified as Class I Generic [IP Communication
Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP
Telephone etc]). The fourth device is Network Connectivity Device, which is typically a
LAN Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point etc.